CBRT has been

Power Supply

A place to ask questions about base setup for CB radios or HAM radios. Talk about your experiences, seek advice, and share knowledge.
Post Reply
User avatar
Gixxer

Power Supply

#29223

Post by Gixxer »

Im looking to purchase a good power supply. Something around 35 amps. What are some good brand names to look at ? And what are the ones to stay away from ?. :twisted:
User avatar
Mr RadioActive

#29224

Post by Mr RadioActive »

Astron is expensive but perhaps the best. They work well under rf loads no problem.
User avatar
BigBopper

#29238

Post by BigBopper »

Pyramid is a cheap power supply,,,that has trouble under loads, and they seem to only last a few years,,,Astron won't fail under loads, cost more than the Pyramid,,but 4-5 times a better unit,,,at least!!
User avatar
Gixxer

#29241

Post by Gixxer »

Sounds like I need an Astron then.. Thanks for the insight . :twisted:
User avatar
DX_949

#29901

Post by DX_949 »

I can highly recommend the MFJ 4245 switching power supply.

45 amp peek 40 amp continuous.
Super light weight.
Super clean, no RF hash in RX or TX.

Variable voltage.

All around excellent PS for the money. ( new $199.95 )

73's
User avatar
Gixxer

#29912

Post by Gixxer »

Thanks guys. I got a RS-70M on the way.
User avatar
mudder

#30256

Post by mudder »

I have an astron 35 amp works great I bought it used and the only thing that broke was the meter on it but the amp still works.get the astron they last.
User avatar
Mr RadioActive

#30348

Post by Mr RadioActive »

Ive had alot of switching power supplies, and always no matter what I do get tons of noise. Ive moved them, braided the pos/neg wires, chokes, moved the cords to different rooms, no matter what brand I use I always get noise...............whats your secret DX_949?
User avatar
Rex_foxhound

#30350

Post by Rex_foxhound »

What exactly does a switching power supply do?

Does that mean you can change the voltage or what?
User avatar
Mr RadioActive

#30353

Post by Mr RadioActive »

A switching-mode power supply is a power supply that provides the power supply function through low loss components such as capacitors, inductors, and transformers -- and the use of switches that are in one of two states, on or off. The advantage is that the switch dissipates very little power in either of these two states and power conversion can be accomplished with minimal power loss, which equates to high efficiency. The term switchmode was widely used for this type of power supply until Motorola, Inc., who used the trademark SWITCHMODE TM for products aimed at the switching-mode power supply market, started to enforce their trademark. Then more generic terms had to be found. I started using the term switching-mode power supply to avoid infringing on the trademark. Others used the term switching power supply, which seems to be the more popular term. PSMA does not define either switching-mode power supply or switching power supply, but does define switching regulator.

Switching Regulator -- A switching circuit that operates in a closed loop system to regulate the power supply output.

CUT AND PASTED RESPONCE
User avatar
518RR

#30377

Post by 518RR »

A day late and dollar short to get to this thread, but I'll also plug Samlex for anyone who might search this out in the future. Astron and Samlex are the way to go in my honest opinion. Well worth every $$ spent.

There's no sense buying a big radio, and then go with a cheap power supply that will induce noise into your signal.

I've got a Samlex sitting here that's done a damn good job with everything I've thrown at it.
Post Reply