Galaxy Clarifier Mod

[Deleted User 30222]

Hello CBRT, I just finished doing the clarifier mod to my Galaxy DX959. Have to say it all went very smooth. With the exception of finished results. When i turn my radio on, all seems fine, but you can here a tone coming from the radio. No other sound whats so ever. I turn the volume up, i hear nothing but a tone. But it does go away when i turn the squelch knob all the way to the left(counterclockwise) If i set the mod switch from swr to pwr, and key the mike. The tx/rx light turns from green to red. Here is the link i used to do the mod.

[Please login or register to view this link]


And here is a pic of my work

[Please login or register to view this link]

[MDYoungblood]

It's really hard to tell by the pics, look at the 8v trace where you soldered the wire and make sure you haven't crossed the solder joints. Look on the component side too, some solder may have flown thru the holes. I hope you didn't over heat the board.

3's

Greg

[295 antenna]

I was thinking the same thing ..look closely it looks like the at the top the to runs are touching

[Deleted User 30222]

I think it was. I went and resoldered it. I know have sound again. But the rx/tx still turns red when i key the mic. Very strange

[MDYoungblood]

The TX/RX led is suppose to turn red on transmit and green on receive.

3's

Greg

[Deleted User 30222]

Well i think i might be ok then. But i did the clarifier mod, but when i turn the knob, it changes from say 27.025 to 27.026. should i not be getting more than that

[MDYoungblood]

On the radio's counter that is all it will read, actual slide is 1.2kc. You will have to do some internet surfing to find a mod to get a little more but most of those mods make the clarifier very touchy.

3's

Greg

[Deleted User 30222]

Yeah, i think i'll just stick with what i have. Although, i am thinking about doing the 10kc mod. But we'll see