CBRT has been

Eagle Tomahawk Base

A place to ask questions about base setup for CB radios or HAM radios. Talk about your experiences, seek advice, and share knowledge.
Post Reply
User avatar
unrealantidote
Skipshooter
Skipshooter
Posts: 224
Joined: Jun 22 2007, 03:45
Contact:

Eagle Tomahawk Base

#114342

Post by unrealantidote »

I have a broken pin where the mic plugs into my Tomahawk in my base. I need some schematics of this radio. also any other adjustments in the radio schematics would be nice. it has been switched to 11 meter already.

I was going to replace the 6 pin connector that comes factory with the tomahawk with a 4 pin because only 4 of the pins are used. the other 2 are for channel and volume and I do not have the stock mic.
1986 F350
4 speed manual Transmission
6.9L IH Diesel
4x4
35x12.50 BFG T/A tires
Uniden PC76xlw CB
Palomar Elite 250 Linear
Eastcoast 4x2879 box
User avatar
BigBopper

#114360

Post by BigBopper »

RV1-RF Power Meter adjust
RV2-Squelch Level adjust
RV4-AM Carrier adjust
RV5-Modulation adjust
RV7-Modulation Meter adjust
RV11-13.8 Volt
RV12-S-Meter Adjust Both AM and SSB.
RV14-SSB ALC adjustment.
RV50-Clarifer Center adjust
Post Reply