First Time Installation

[LordDragr]

I just ordered a 2 pill fatboy from Mud Duck Electronics. I have a 2000 Ford Ranger, I know we got a few ranger drivers here so What will I need to do to properly install it? What will I need to get so I wont have any problems?

[stickman]

I WOULD RUN 10 GAUGE WIRE, RUN BOTH POSTIVE & NEGATIVE TO THE BATTERY, POSTIVE TO POSTIVE AND NEG. TO NEG. GET A JUMPER BY PUTTING INTO A RANGER I WOULD USE 3FT. JUMPER!! HOOK IT ALL UP AND YOU SHOULD BE WALKING THE DOG!!!
STICKMAN

[Phaze91460]

Run a cupla fuses, one on each leg from battery. At least 50A

[MudDuck]

I would run either 10 or 8 gauge power wire, with 50Amp anderson quick disconnects... Ground vehicle with grounding straps to help cut back RF... Also make sure that the swr is 1.3 or less... Rg-213 coax or RG-8XX (mini grey)...

Let me know if you need quick disconnects!!!

Good luck with the amp Lord Dragr

Steve

[Punkin Head]

run 8ga wire from poss on battery to amp and from neg on battery to frame then from the neg wire on amp to frame. put 50a fuse inline. set your swr's to 1.3 or less then put your boots on and stomp on some mudducks lol.

[LordDragr]

where can I pick up some RG213? Mud Duck I guess I could use some quick disconnects.